Tuesday, September 03, 2013

Embroidered Hostess Apron

D7K_4084

I love wearing aprons in the kitchen—especially half aprons, or hostess aprons as I like to call them. This apron took me about 45 minutes to sew and about that long to embroider as well. I did use large embroidery motifs in my Bernina “Mega” hoop, so that’s why it took so long to embroider.

Start with a piece of already-washed-and-pressed natural linen. I used 4C22 from fabrics-store.com in the color “natural”.  Cut it 26”x17” inches.  (I would cut the linen 26”x20" instead if this apron were for me as I am 5’10”.)

Embroider as desired. Or not, up to you! I used designs from my shop—Cross Stitch Alphabet Regular (1” for the ABC sampler and 3” for cake/pie), plus the Cross Stitch Lemoyne star.

After embroidering, cut rounded bottom corners with something fancy like a cereal bowl as a template:

IMG_3137

Make some 2” bias tape (It must be cut on the bias to go around the curves!) Sandwich the apron between the bias tape, and stitch a zig zag stitch all around the two sides and the bottom of the apron. (If you don’t know how to make bias tape there are about a thousand tutorials out there. Just google it, I promise.)

 IMG_3138

I like to make extra bias tape when I do make it because it’s always nice to have on hand for a quick project, like this. Smile

IMG_3155

Stretch the bias ever-so-slightly as you go around the rounded corners. (As seen below.) When I say stretch, I mean tug just enough to make a smooth rounded turn. If you actually pull and stretch it too much you’ll have a wavy apron—not good.

IMG_3154

For the waist ties: Cut two strips of fabric (selvedge to selvedge) 5” wide each. (For teens and skinny ladies this will be enough length to wrap around your back and tie in front. For fuller figures, cut 3 strips. However, to tie in the back you only need two strips no matter your size.) Attach them together on the bias, as seen below. To do this, start  by drawing a 45 degree diagonal line on one of the strips. Pin the strips together and sew through diagonal line.

IMG_3139

Cut off excess:

IMG_3140

Fold in raw edges 1/2” and iron with steam or better yet, spray starch.

IMG_3142

Then fold in raw ends, make a point,  and iron into place as seen below:

IMG_3146

Sandwich your apron between the ties and pin in place. Make sure you center the apron between the full length of the ties.

IMG_3149

Sew the full length of the ties from pointy end to pointy end. I went back and stitched again just on the apron part—this is good to do if you didn’t “catch” all of the ties fabric on the backside.

IMG_3150

You’re all done!! But if you want to add a rounded pocket, cut a rectangle 7x9” of fabric and super thin fusible interfacing. Round the bottom corners. Put the right side of the fabric facing the non-gluey side of the interfacing. Stitch around the side and bottom and notch at rounded corners.

IMG_3152

Turn right side out, push out interfacing tight especially at corners, and iron/fuse into place. Important: make sure you can’t see the interfacing from the right side of the pocket! Serge off the top or zig zag. Fold down an inch at the top and topstitch.

IMG_3153

Place pocket on apron in desired spot and topstitch around side and bottom. Voila! A perfectly rounded pocket!

IMG_3156

D7K_4080

D7K_4095

D7K_4087

Enjoy your apron by making a cake. Or pie. Subliminal message, huh?

No comments:

LinkWithin

Related Posts Plugin for WordPress, Blogger...